Emisil 2&1 Prosthetic StP1 en StP3 en Emisil 4&1 StP2
Your new Emisil prosthetic just came in - amazing! We’ve collected some important information to help you get started with the silicone prosthetic.
Instruction
Emisil StP-prosthetics can be used both with skin adhesive and harnesses. StP prosthetics can be worn on the skin all day. Some models can also be worn during the day as a packer.
If you’re going to use the packer with a skin adhesive, make sure the skin is hairless, dry, and clean. Use a medically approved adhesive. Apply some product to the silicone skin tab, wait a few seconds for the glue to thicken, then press the prosthetic against your lower belly. Make changes if necessary (do this before the glue dries!). Apply light pressure until the adhesive dries and check if your prosthetic is attached securely. Once the glue dries, the prosthetic can stay there for 8-12 hours.
To pee with your StP-prosthetic, keep the prosthetic in place with one hand and press the cup against your vulva. It’s useful to wear a pair of jeans that have a zipper that can go quite low, so that the urine flow isn’t interrupted. Please note: using an StP-prosthetic takes a little bit of practice, take your time practicing at home in your shower or bathroom. After you’ve finished urinating, lift the cup slightly to get rid of any leftover drops. Watch the video below for a visual explanation.
At the end of the day you can lightly pull on the prosthetic and remove the glue with a medically approved adhesive remover.
The Emisil 2&1 Prosthetic StP1 en the Emisil Prosthetic 4&1 StP2 come with an erection rod and are suitable to use during intercourse. The Erection Rod can be inserted into the funnel. We advise you to wear a harness on top of the skin adhesive to make sure your prosthetic stays in place.
Use
You can wear your StP-prosthetic all day, as long as you’re certain you’re not allergic to the material of the prosthetic or the adhesive. If you notice any skin irritation, remove the prosthetic as soon as possible. Emisil prosthetics can safely be used in salt- and chlorine water, but please note that excessive use in the water can cause the material to disintegrate faster.
Cleaning
To make sure your StP-prosthetic is properly cleaned we advise you to wash it before and after every wear. Wash the prosthetic in lukewarm water with some mild soap and let the prosthetic dry on a towel. You don’t have to wash the prosthetic each time after you’ve gone to the bathroom - do it at the end of the day.
The erection rod that comes with the Emisil 2&1 Prosthetic StP1 and the Emisil 4&1 Prosthetic StP2 can also be cleaned with lukewarm water and soap.
Storing
Do not leave your packer out in direct sunlight. Store the prosthetic in a dry and cool place. Don’t let your prosthetic rub other silicone products where they’re stored.
Emisil FL05
Instruction
The Emisil FL05 can be used both with skin adhesive and a harness. Emisil packers can safely be worn on the skin. Place the prosthetic in your underwear and move it in the desired position. Watch the video below for a visual explanation on how to wear your prosthetic with a harness.
If you want to wear the packer with skin adhesive, make sure the skin is hairless, clean, and dry. Use a medically approved skin adhesive. Apply some glue on the silicone skin tab, wait a few moments for the glue to dry a little, then press the prosthetic against your lower belly. Readjust the packer if needed (do this before the glue dries). Lightly apply pressure and check if your prosthetic is securely attached. Once the glue dries the prosthetic can stay on for 8 to 12 hours.
At the end of the day you can gently pull on the prosthetic and remove the glue with some adhesive remover.
Please note that this prosthetic is not suitable for sexual intercourse.
Use
You can safely use the Emisil FL05 for the whole day, as long as you’re certain you’re not sensitive to the material. If your skin gets irritated, remove the prosthetic as soon as possible. Emisil prosthetics can be safely used in chlorine or salt water, but note that excessive use in water can make the material disintegrate faster.
Cleaning
We advise you to clean the Emisil FL05 before and after each use. Wash the prosthetic in lukewarm water with mild soap and let the prosthetic dry on a towel.
Storing
Do not leave your prosthetic out in direct sunlight. Store the prosthetic in a dry and cool place. Don’t let your prosthetic rub other silicone products where they’re stored.
Emisil Erect Prosthetic ER01, ER02, ER04 and ER12
Instruction
Emisil Erect Prosthetics can best be used in combination with a harness. A harness will make sure the prosthetic stays in place during sexual intercourse. It’s also possible to attach the prosthetic with skin adhesive - but note that a harness will function the best at keeping the prosthetic in place.
If you want to wear the packer with a skin adhesive, make sure the skin is free of hair, dirt and moisture. Use a medically approved skin adhesive. Apply some glue on the silicone skin tab, wait a few seconds, and press the prosthetic against your lower belly. Make minor adjustments in the position (do this before the glue dries!). Apply light pressure until the glue dries and check if your prosthetic is securely attached. After using you can softly pull on the prosthetic and dissolve the glue with some glue-remover.
Gebruik
You can use the Emisil Prosthetics during sexual intercourse without it irritating the skin. If you do notice any irritation or skin damage, remove the prosthetic immediately. Emisil Prosthetics are made to withstand chlorine- and salt water, but do note that excessive use in water can make the material disintegrate faster.
If you’re going to use lube with these prosthetics, make sure that it’s a water-based lube. Silicone-based lube can damage the prosthesis.
Cleaning
To make sure your prosthetic is properly cleaned we advise you to wash it before and after every wear. Wash the prosthetic in lukewarm water with some mild soap and let the prosthetic dry on a towel.
Storing
Do not leave your prosthetic out in direct sunlight. Store the prosthetic in a dry and cool place. Don’t let your prosthetic rub other silicone products where they’re stored.